Home > Interface Controller CG1

Interface Controller - For improved reliability of the emergency stop circuit -

CG1.2c.jpg

The CG series can detect on/off and wire-breaking states

when used in conjunction with Tokyo Sensor switch products.

●There are 2 functions as below.

  Self-holding mode

   The output state is switched upon detection

   of a contact between switch contacts.

  Wire-breaking detection

   The output state is switched

   upon detection of wire break,

   even though instant wire break.

●Applicable for 4-wire system switches and

 terminating-register-integrated switches only

 
 
 

Type

CG1 series

 

CG2

CG1en.png   CG2en.png

Install For Control Panel

Available for AC100 to 240V.

 

Not using mechanical relay, compact, and Low power consumption, it's good for AGV and Mobile Robot.

 For:Tape Switch, Edge Switch, and Mat Switch

 

 For:Tape Switch, Edge Switch, and Bumper Switch

See Instruction manual